Marmodom ELASTIC PRO 25 kg Elastic tile adhesive C2TES1

Elastic tile adhesive C2TES1

ELASTIC PRO adhesive is used for laying tiles and slabs of any type and dimensions, such as ceramic or artificial materials, as well as natural building stones, etc., on floors and walls. Suitable for interior or exterior surfaces. It can be applied on conventional concrete substrates and cementitious coatings, on surfaces made of lightweight structural elements (porous concrete blocks, cement and plasterboards, etc.), in areas with relatively high requirements in terms of temperature changes and humidity (heated floors, balconies, bathrooms, etc.). It ensures very good adhesion, high resistance to compression and bending, as well as to changes in temperature and humidity and environmental changes. It prevents visual changes in the surface of white marble (and other building materials) and the formation of efflorescence. Homogeneous, ready-to-mix, industrial product of consistently high quality. Ensures good workability, increased application speed, is economical and provides excellent results.

Composition & Characteristics:

- Mixture of high quality white cement and strictly selected particle size and quality of crushed marble, enriched with polymers and other special improving additives.

- It complies with EN12004-1 as C2TES1.

Application:

-The substrate must be clean and stable, and it is recommended that it is wetted before application.

- The contents of the bag are gradually added to clean water (approximately 4,5-5,0 l/bag) under continuous stirring using an electric mixer at low speed until a homogeneous mixture is obtained. The mixture is allowed to cure for 5 minutes and then stirred again before application.

- The application of the adhesive ("combing") should be done with a notched trowel (6-10 mm). The tiles should be placed and pressed to come to the desired position within 30 minutes. The limits of the application time of the adhesive prepared are such that any corrections are possible to allow the tiles to be fixed in their exact final position.

- If the substrate has been covered with a coating, its moisture content must be less than 2,5 % before applying the adhesive.

- During the application of the adhesive, and for a few hours afterwards, extreme climatic conditions (such as strong wind, rain, dust, direct sunlight, etc.) should be avoided and the temperature should be between +5 oC and 35 oC.

- Floor grouting can be done after 24 hours while wall grouting after 8 hours.

- For even better quality results, please refer to the related MARMOPLUS product.

Packaging & Storage:

- In 25 kg bags, pallets and 5 kg containers.

- In a dry place where frost does not form, for 12 months from the date of production, in unopened bags.