Marmodom MARMOFINISH FW EXTRA FINE 25 kg Pressed cement mortar for floors and walls - Final fine layer

MARMOFINISH FW EXTRA FINE is a cementitious mortar used indoors and outdoors as a top coat in the MARMOFINISH cementitious mortar system. It ensures very good mechanical properties, while at the same time giving a high aesthetic effect. Homogeneous, ready to mix, industrial product of consistently high quality. Ensures good workability, increased application speed, is economical and provides excellent results.

Composition & Ingredients:

- Mixture of high quality white cement and strictly selected particle size and quality of crushed marble enriched with special improving additives.

- Classified according to EN 1504-3:2005 as: (R1-PCC) concrete repair mortar for non-structural repairs.

Application:

- The substrate (MARMOFINISH FW) must be dry, clean and cured.

- The contents of the MARMOFINISH FW EXTRA FINE bag are gradually added to clean water or to water in which the desired dye has been previously dissolved (5,0-5,5 l/bag) under continuous stirring using an electric mixer at low speed until a homogeneous mixture is obtained. The mixture is allowed to cure for 5 minutes and then stirred again before application.

- MARMOFINISH FW EXTRA FINE is then applied using a smooth trowel and the surface is smoothed, pressed, to prevent the formation of bubbles inside the material. It is important that the spatula runs over the entire surface, pressing at every point.

- In the application phase of MARMOFINISH FW EXTRA FINE, pigments can be added to the mixture, which with the appropriate style will create "waters" in various tones on the final surface, giving a unique aesthetic effect.

- After 2-3 days, the polyurethane varnish PROTECTOR SHIELD (gloss or matt) is impregnated on the surface and gives the final surface water repellency, high mechanical strength, stability and resistance to stains.

- Usually, the application of polyurethane varnishes changes the colour of the surface. If this is not desirable it is recommended to apply an intermediate coat of PROTECTOR SHIELD ACRYL.

- On large surfaces care must be taken to provide expansion joints.

- For even better results, please refer to the relevant MARMOLATEX product.

- During the first 24 hours after application and especially in the summer months, it is recommended to wet the surface to avoid possible cracking due to sudden evaporation of water and dehydration of the product.

- During application, extreme climatic conditions such as strong wind, rain, etc. should be avoided. and the temperature should be between +5 oC and +35 oC.

Packaging & Storage:

- In 25 kg bags, on pallets.

- In a dry, frost-free place for 12 months from the date of production, in unopened bags.

Consumption:

Approximately 1,5 kg/m2 for a thickness of 1 mm ,depending on the type of substrate.