Marmodom FLS 2000 C2TES2 20kg Flexible tile and marble adhesive "ULTRA ELASTIC" (White) C2TES2

FLS 2000 adhesive is used for the installation of tiles of any type and dimensions (marble, granite, ceramic, etc.) on any substrate, interior or exterior, on floors and walls. ), on metal surfaces, in swimming pools, water tanks, on surfaces with relatively high humidity, on floors and walls with increased demands on temperature changes, expansion joints or vibrations (heated floors, bathrooms, balconies, metal substrates, etc.) and wherever high construction quality is required. It ensures very good adhesion, high resistance to compression and bending, with characteristic stability to temperature and humidity changes. It prevents visual changes in the surface of white marble (and other building materials) and the formation of efflorescence. Homogeneous, ready-to-mix, industrial product of consistently high quality. Ensures good workability, increased application speed, is economical and provides excellent results.

APPLICATION:

- The substrate must be clean and stable and it is recommended that it be wetted prior to application.

- The contents of the bag are gradually added to clean water (approximately 4,5-5,0 l/bag) under continuous stirring using an electric mixer at low speed until a homogeneous mixture is obtained. The mixture is allowed to cure for 5 minutes and then stirred again before application.

- The application of the adhesive ('combing') should be done with a notched trowel (6-10 mm) and then the tiles are placed within 30 minutes.

- The tiles must be placed and pressed down to get them in the desired position. The application time limits of the prepared adhesive are such that any corrections are possible to ensure that the tiles are fixed in their exact final position.

- If the substrate has been covered with a coating, its moisture content must be less than 2,5 % before the adhesive is applied.

- Extreme climatic conditions (such as strong wind, rain, dust, direct sunlight, etc.) should be avoided during the application of the adhesive and for a few hours afterwards.

- Application temperature between +5 °C and +35 °C.

- Floor grouting is recommended after 24 hours and wall grouting after 8 hours.

RECOMMENDATION & CHARACTERISTICS:

- Mixture of high quality white cement and strictly selected particle size and quality of crushed marble, enriched with special improving additives.

- It complies with EN 12004-1 and is classified as C2TES2 adhesive.

STORAGE:

- In bags of 20 kg, on pallets.

- In a dry place where frost does not form, for 12 months from the date of production, in unopened bags.

CONSUMPTION:

2.0-4.0 kg/m2, depending on the type and size of the tiles as well as the substrate.